Many players know little about electronic cigarette-related knowledge, in the course of vaping, a slight mistake will cause the leaking of oil. What is oil-leaking? Oil leak in a non-normal way such as flowing from the outer side of the spray chamber glass, atomizer base or the side of the drip tip. Leaking is always caused by people’s misuse rather than the kit itself. On common circumstance, we should pay attention to the following reasons, especially the new vapers.

1.Full and fast refilling(novice commonly face the problem) 

Some novice friends refill too fast or too full so that the coil is saturated or part of the oil has not been absorbed by the bottom base instead of being absorbed by the coil，causing the oil-leaking. 
Solution:2/3 of the tank is that much of the oil and more will lead to the leaking. You can refill several times at little amount or when you vape out, you refill again. This is determined by the structure and working principle of the atomizer. Oil permeate the coil through the atomizer holes and then the heating of the oil from the coil will turn the oil into vapor . If the tank is filled oil and has little capacity,which leads to the low pressure, then the oil will not be burnt completely, you would probably vape a mouth of oil.

2.The misuse of kit

Many vapers are in the habit of blowing to the atomizer before they are vaping, which is inappropriate. First of all, the structure of sub-ohm tank differs from the RDA. Your blowing will bring the frying oil to the bottom and accompany by the accumulation of condensate, oil-leaking appeared. 
Solution: Do not blow to the kit and if you feel an ear of bubbling, your tank may have drips of condensation, all you have to do is just to throw the kit away of the drips.

3.The losing or damage of the rubber rings

In the course of the use of atomizer, the most likely losing things are the sealed rubber rings. If the rubber rings of contacting the base and the coil are damaged or missing, there will be leakage of the oil.
Solution: When you unscrew the atomizer to refill, you’d better not to touch the rubber rings. If the screws are not tightly kept, there will be no sealed effect. If the rubber rings are missing or damaged, replace them with a new one.  

4.The screws are not tighten up

The connection of the oil tank and the mod are tighten up by rubber rings and if the screws are not tighten up and the rubber rings haven’t been squeezed, the seal will be of no effect, leading to the oil-leaking.  
Solution: Tight the screws until they can’t be tighten up.

5. Strong or quick suck of the oil. 

We often gain complaint about sucking a lot of oil from the novice friends and many often them fear there is poor quality of the items. In fact, it is due to the quick or strong suck of the vape.The ecigs are unlike the traditional cigarettes, burning more quickly if you smoke at a larger mouth while the ecigs are having bigger vapor by vaping for a longer time. 
Solution:Do not smoke from downside of the kit , but to vape from the 45 degrees upward . Do not suck too fast at a mouth, but to maintain a smooth and appropriate force to breathe. If you vape too fast, the condensation will be sucked to your mouth.

6. Long-time placement

If the atomizer is laid for a long time with rest of the oil in the kit, there will be oil-leaking because most of the atomizers are pressure-type oil structure. Due to a long time pressure, the leading of the oil will exist all the time and the accumulation of the oil will go to the base and leak to oil-leaking.
Solution: Fill as much as you can vape.

Come to Cacuq forum to know more about newest ecigs news!

tags:ecigs information, ecigs industry news, online ecigs store